LIMODOR One

Humidity, CO2 and VOC control modules can be easily attached to the outside of the fan insert in a few simple steps. A fan insert with integrated motion module is required for motion control.

The degree of soiling is checked visually via the app and the correct replacement filter can be ordered directly from the online store if required.

After installation, a test run of the fan insert is started on the app. This checks its proper function and correct installation. Malfunctions are displayed and troubleshooting is supported. This prevents later complaints.

No. This is not necessary thanks to the NFC technology. The fan can even be configured in advance while still packaged. This saves installation time.

Depending on the existing control variant, various parameters in the existing templates can be individually adapted and saved under a new name.

Typical fan settings in different rooms can be called up from a template library in the app on the cell phone. They can be transferred to the ventilation insert with just one click via NFC. This is then ready to start immediately.

Regardless of the installation position, the NFC chip is always located in the center of the device and is therefore easy to find.

No, all settings are only transferred quickly and conveniently from the LIMODOR app to the fan via NFC.

A separate 50 mm connection piece is available for the toilet bowl connection.

Yes, the housing variant available for this is 100% leak-proof and dimensionally stable thanks to a polystyrene insert that can be removed later. The interior is thus protected against concrete penetration and deformation. The housing is simply nailed to the formwork before concreting.

Pipe systems only need to be pushed on or inserted and are immediately tight. They do not need to be additionally attached to the spigot. The entire fan insert simply snaps gently into the housing and is immediately ready for use. No tools are required to (dis)assemble the filter and cover either.

Suction is possible from the front, from below (toilet bowl suction) and exclusively also from the rear of the fan. Blowing out either to the rear (4 possible positions), upwards / downwards, sideways to the top right / bottom left).

All seals are integrated during the production process. This means they are protected against damage, cannot be lost and are not unintentionally deformed or pushed out when the pipe is pushed on.

All common pipe systems – e.g. plastic pipes and hoses, spiral ducts, Aluflex or corrugated pipes – can be fitted on the inside or outside without additional fastening and sealing measures (sealing tape, clamps, etc.).